SPRINGSTEP INSTALLATION

SPRINGSTEP II

CONSTRUCTION

1) Two layers of 1/2" (12.70 mm) underlayment grade solid core no void plywood, one side finished. 2) Stagestep's 2" (50.80 mm) high density cubed foam blocks. 3) Contact cement or liquid nails, not necessary if using peel and stick cubes. 4) 1-1/2" (25.40 mm) continuous thread wood deck screws with counter sinking heads. 5) Tape floor patch to fill screw holes and realize a smooth surface. Do not use drywall screws or nails.

• Seal concrete slab against moisture
• Glue or peel and stick foam blocks to bottom layer of ply.
• Run top layer of ply perpendicular to bottom layer
• Tape or patch screw heads and sand seams

Note: Do not patch seams

CAUTION:

By using substandard wood and/or hardwood, you increase the risk of subfloor failure. Rough edges, defective or non-specified screws can result in damage to your wear surface. Double check that your subfloor is secure and sound.

Do not use any wood with moisture content exceeding 10%.